Disassembly/Reassembly; Tool Requirements; Cpu Circuit Board Removal; Figure 4-1 Cash Box & Course Path Reversing Guide Cover Removal - JCM GLOBAL VEGA Series Operation And Maintenance Manual

Table of Contents

Advertisement

4 DISASSEMBLY/REASSEMBLY

This section provides disassembly and reassembly
instruction for the VEGA Banknote Validator.
This section contains the following information:

Tool Requirements

CPU Circuit Board Removal

Upper Sensor Circuit Board Removal
Sub-Circuit Board Removal
Feed and Stacker Motor Removal
Sub-Sensor Circuit Board Removal
Lower Sensor Circuit Board Removal
Transport Belt Removal
Stacker Belt Removal
Tool Requirements
The following tools will be required to perform
disassembly and reassembly.
#1 Phillips Screwdriver
Flat Blade Screwdriver
E-Ring Holder
Tweezer
CPU Circuit Board Removal
To remove the VEGA Unit's CPU Board, proceed
as follows:
1. Remove the VEGA Cash Box (Figure 4-1 a)
from the Frame (Figure 4-1 b).
2. Remove the Course Path Reversing Guide Cover
(Figure 4-1 c) from the Upper Transport Unit
(Figure 4-1 d).
Figure 4-1 Cash Box & Course Path Revers-
ing Guide Cover Removal
d
b
Figure 4-1 Cash Box & Course Path Reversing
Guide Cover Removal
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series
Banknote Validator
S e c t i o n 4
c
a
NOTE: To remove the VEGA SD/SU
Unit from the Host Machine, refer to
"SD/SU Unit Installation" on page 2-
1 and perform reverse operation.
3. Remove the four (4) Frame Mounting Screw
from each side of the VEGA Unit's Frame (Fig-
ure 4-2
a
through
1
4. Separate the VEGA Unit (Figure 4-2 b) from the
Lower Frame Section by lifting up and off the
Cash Box Frame (Figure 4-2 c).

Figure 4-2 Cash Box Frame Removal

a
1
a
2
Figure 4-2 Cash Box Frame Removal
5. Open and hold the Upper Transport Unit (Figure
4-3 a).
6. Use a Flat Blade Screwdriver to release the two
(2) Claw Hooks (Figure 4-3
Harness Cover by pressing-in on them through
the slot opening located on each side of the
Upper Transport Unit, and lift and separate the
two (2) Covers from retaining the Connector in
place (Figure 4-3 c).
7. Unplug the two (2) Signal Connectors from the
CPU Board on the opened Upper Transport Unit.
© 2016, JAPAN CASH MACHINE CO., LTD.
4 - 1
a
).
4
b
a
4
a
c
b
&
b
) of each
1
2
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents