Reassembly - Honda Acura NSX 1991 Service Manual

CAUTION:
taminate the brake fluid.
surfaces as it can damage the finish.
Wash spilled brake fluid off immediately with clean
water.
Pack all cavities of the needle bearing with a com-
1.
mercially available assembly
2. Coat the new cam boot with a commercially
available assembly lube and install in the caliper.
3. Install the cam with threaded end facing up.
CAUTION:
installed before the cam.
boot lips to turn outside in.
CAM
Assembly lube
BEARING
lube
ROLLER
4. Install the lever, lock washer and parking nut, then
tighten the parking nut.
5. Install the return spring.
RETURN
LEVER
6. Install the pin in the cam.
7. Install a new O-ring on the sleeve piston.
8. Install the sleeve piston so the hole in the bottom of
the piston is aligned with the pin in the cam, and
two pins on the piston are aligned with the holes in
the caliper.
O - R I N G
PARKING NUT
28 N*m
20 lb-ft)
(2.8 kg-m,
HOLES
'CAM
19-23