Honda Acura NSX 1991 Service Manual page 534

Transmission
27. Install the 3 transmission mounting bolts, and the 2
transmission housing mounting bolts.
28. Install the starter motor and tighten the starter motor
mounting bolts.
29. Install the ATF cooler.
30. Connect the transmission ground cable, starter motor
cable, solenoid valve wire connectors and speed sen-
sor wire connectors.
31. Install the control box and connect the control box
connectors.
32. Install the air cleaner case.
33. Install the strut bar.
TORQUE: 39 N-m (3.9 kg-m, 28 lb-ftj
14-152
34. Refill the transmission with ATF.
35. Connect the battery positive ( + j and negative (- j ca-
ble to the battery.
36. Inspect the rear camber (See Section 18).
37. Start the engine. Set the parking brake, and shift the
transmission through all gears three times. Check for
proper shift cable adjustment.
38. Check the ignition timing (See Section 23).
39. Let the engine each operating temperature with the
transmission in Neutral or Park, then turn it off and
check the fluid level.
40. Road test as described on page 14-88.
MOUNTING BOLT
12x 1.26mm
75 N-m (7.5 kg-m, 54 lb-ft)
A
CONTROL BOX