Honda Acura NSX 1991 Service Manual page 561

7. Install the spring and cap, than fit the outboard
joint onto the driveshaft.
OUTBOARD JOINT
Align the roller holders with the
inboard joint as shown
below.
8. Fit the circlip into the outboard joint inner groove.
inboard joint side
9. Install the inboard boot to the driveshaft, then
HOLDER
IO. Install the set ring into the driveshaft groove.
11. Install the spider on the driveshaft by aligning the
12. Install the set ring into the driveshaft groove.
NOTE: Wrap the splines with vinyl tape to prevent
damage to the boot.
remove the vinyl tape.
INBOARD BOOT
marks on the spider and end of the driveshaft.
SET RING
M a r k
SET RING -
M a r
ER
16-9