Troubleshooting
-Troubleshooting
l
Always use the test harness to verify the resistance, voltage, current and other electrical characteristics for the EPS
control unit, torque sensor, steering circuit sensor, power unit, and their connectors.
The test probe must not make direct.contact
A digital circuit tester must be used to perform the inspections.
l
An analog circuit tester must be used only when this procedure is indicated in the specification figures.
l
The EPS system connector should not be disconnected except when necessary.
Inspect the connection condition and ground of each EPS system connector before peforming the troubleshooting
l
procedures.
17-42
Precautions
with the connector terminals.