Honda Acura NSX 1991 Service Manual page 1056

Dash Fuse Box
Removal/Installation
CAUTION;
Be sure to install the SRS wiring so that it is not
l
pinched or interfering with other car parts.
l Always keep the short connector on the airbag con-
nector when the harness is disconnected.
Removal:
1 . Disconnect both the negative cable and positive ca-
ble from the battery.
2. Remove the maintenance lid A below the airbag,
then remove the short connector.
SHORT C
3. Disconnect the connector between the airbag and
cable reel.
4. Connect the short connector to the airbag side of
the connector.
STEERING WHEEL
SHORT CONNECtOR (RED)
23-70
LID A
I
I
5 . Remove the door sill molding.
6 . Remove the kick panel trim pieces, as necessary.
7 . Remove the fuse box mounting bolts.
8 . Disconnect the fuse box connectors.
NOTE: The SRS main harness connector is double
locked. To remove it, first lift the connector lid with
a thin screwdriver, then press the connector tab
down and pull the connector out.
9. Take out the fuse box.
L I D
No. 1 (IO A)
TRIM
KICK PANEL
TAB
N CIARNESS
MAI