Honda Acura NSX 1991 Service Manual page 653

Wheel Alignment
NOTE:
l NSX four wheel alignment requires the use of equip-
ment designed specifically for four wheel indepen-
dent suspensions and capable of immediate
feedback.
ment. For every 10 mm of change in the front ride
height, the camber will change approximately IO
minutes.
interactive.
A slight change in toe will dramatically change the
camber.
1 . Drive the car on the alignment rack.
2. Check the tire pressure and ride height as described
on page 18-6.
3. Center the steering wheel.
Toe
the right and left .r:ck ends.
Standard: 11 mm for shoulder
Difference between right and left: 1 mm max.
-2. If the measurement is out of the specification,
loosen the locknut and adjust properly.
LOCKNUT
44 Nom
Camber
arm adjusting point and adjust the cam posi-
tion so that the right and left gaduations on
the adjusting cam are in contact.
-2. Mark the arm in the position which aligns with
the dial center of the adjusting cam.
Graduation in contact
with groove wall
contact with
Loosen the nut
125 Nom
(12.5 "v-m, 90 lb-ft)