Honda Acura NSX 1991 Service Manual page 596

20. Install the pinion set screw locknut, then hold the
pinion set screw and tighten the locknut to a torque
wrench reading [indicated) of 54 - 69 N-m (5.4 - 6.9
kg-m,
NOTE: The above specification is the torque wrench
reading (indicated) when the set screw is tightened
using a torque wrench 50 cm (20 inches) long. If you
tighten the set screw using a torque wrench of the
different length, obtain the indicated torque value
(torque wrench reading) using the formulas shown
in the step 17.
Actual: 70-90 N-m (7-9 kg-m, 50-65 lb-ft)
indicated: 54-69 N-m (5.4-6.9 kg-m, 39-50
lb-ft)
Tool length (B): 15 cm (6 in)
21. Turn the pinion shaft slowly, then insert the rack
and engage the rack and pinion gears.
PINION SCREW WRENCH
22. The system is in neutral when the rack end projects
60 mm (2.34 in) from the cylinder end.
23. Install the rack guide, pressure plate, pressure spring
and rack screw guide.
RACK GblbE
RACK GtlDE
S C R E W
24. Tighten, loosen and retighten the rack guide screw
two times to 5 N-m 10.5
it off 15O.
60 mm (2.34 inl
\
\
*RACK GUiDE LOCKNUT
3.6 lb-ft), then back
kg-m,