Honda Acura NSX 1991 Service Manual page 529

10. Install the feed pipes and ball bearing in the L. Side
Cover, aligning the lugs of the 1st and Ist-hold clutch
feed pipes with the grooves of the L. side cover.
11. Install the snap ring.
12. Install the L. Side Cover.
TORQUE: 12 N-m (I kg-m, 9 lb-it)
BALL BEARING
13. Install the speed sensors, speed sensor cover and
linear solenoid.
TORQUE: 12 N-m (1.2 kg-m, 9 lb-ft)
SENSOR
COVER
NM SPEED SENSOR
14. Install the control lever, new lock washers, change
shaft and change shaft cap
control shaft. Tighten the bolts and then bend the tab
over against the bolt head.
6x
12 N.m (I .2 kg-m, 9 lb-ftl
CONTROL CONTROL
LEVER
LINEAR SOLENOID
6x l.Omm
10 N.m (1.0 kg-m, 7 lb4
the other end of the
on
CHANGE SHAFT CAP
CHANGE SHAFT CHANGE SHAFT
TROL SHAFT TROL SHAFT
LOCK WASHER