Honda Acura NSX 1991 Service Manual page 637

CAUTION: Before removing the gearbox, place a stand
jack under the gearbox and front cross-beam to lightly
support them.
Lower the gearbox together with the cross-beam.
1 7 . R e m o v e t h e b o l t s a n d n u t s o f t h e g e a r b o x a n d
cross-beam.
mm
60 N-m (6.0 kg-m, 43 lb-ft)
FLANGE BOLT
(Cross-beam bracket
to Front cross beam)
A
60N.m
(6.0 kg-m,
FLANGE BOLTS
43 lb-ft)
(Gearbox to
Front cross beam)
LEFT SIDE
RIGHT SIDED
FLANGE BOLT
60N.m
(6.0 kg-m, 43 lb-ft)
(Gearbox to Front
cross beam),
FLANGE BOLT
60N.m
to cross beam bracket)
m m
FLANGE BOLT
(Cross-beam bracket
to front yoss b e a m )
60N.m
m m
FLANGE BOLT
60N.m
(6.0 kg-m, 43 lb-ft)
(Gearbox to FI
cross beam)
FLANGE BOLT
60N.m
(6.0 kg-m, 43 lb-ft)
(Front cross beam to
cross beam bracket)
mm
(6.0 kg-m. 43 lb-ft)
(Front cross beam
18. Lower the gearbox and cross-beam with care so as
not to interfere with the radiator pipe.
NOTE: The cross beam
beam bracket with knock
Remove the cross beam by lightly taping on it with
a plastic hammer, then remove the gearbox.
FRONT CROSS/ BEAM
19. When installing the
cross
bracket, be sure to align the holes in the cross beam
with the knock pins on the cross beam bracket.
is attached to the cross
pins.
ASSEMBLY
beam to the
cross beam
PIN