Honda Acura NSX 1991 Service Manual page 583

Steering Column
STEERING CO
ASSEMBLY
8x 1.25 mm NlJi
1 6 N-m
(1.6 kg-m, 12 lb-ft)
NOTE:
Check the telescopic mechanism, tilt mechanism, and steering joint bearings or steering shaft for movement and damage.
l
Replace as an assembly if damaged or faulty.
If either the steering column assembly or TCS sensor is removed, select the appropriate shim and adjust the distance
l
between the steering shaft and TCS sensor. Refer to Section 19 for shim selection.
Measure the force required to move the lever.
Preload: 70-90 N (7 -9 kg, 15-20 Ibs)
17-14
6 m m
SOCKET BOLT
8 x 1.25 mm
BOLT/WASHERS
23 N'm
(2.3 kg-m.
1 7 lb-ft)
CLAMPS
If the force measured is not within the specification, loos-
en the locknut then the telescopic adjusting bolt until the
correct force can be obtained.
damage.
Check for
S T Y O K E
E E R I N G
BOLTS
23 N-m
17 lb-ft)
CLIP
JOINT COVER