Honda Acura NSX 1991 Service Manual page 346

28. Remove the one of the upper control arm mounting bolts.
29. Remove the lower cover, change wire braket and upper cover.
30. Remove the shift cable and select cable.
31. Remove the slave cylinder from the transmission.
NOTE: Do not operate the clutch pedal once the slave
cylinder has been removed.
32. Remove the release fork from the clutch release hanger,
then hang the release fork on the clutch housing.
BOLT
33. Remove the clutch housing cover.
34. Attach a chain hoist to the transmission hangers.
35. Place a jack under the transmission and raise the transmission just enough to take weight off mounts.
36. Remove the front engine mounting bolts on the transmission side and retighten the bolt on the engine side.
CAUTION: Loosen the front engine mounting bolt on the engine side, but do not remove it. After removing the two
bolts on the transmission side, be sure to retighten the bolt on the engine side.
37. Remove the rear transmission mounting bolts and engine stiffener.
38. Remove the transmission housing mounting bolts.
39. Pull the transmission away from the engine until it clears the Mainshaft, then lower it on the transmission jack.
TRANSMISSION
MOUNTING BOLT
TRANSMISSION JACK
TRANSMISSION HOUSING
MOUNTING BOLT
SLAVE CYLINDER
A S S E M B L Y
SHIFT CABLE
CHANGE WIR
- C L U T C H
ENGINE STIFFENER
RELEASE FORK
LOWER COVER
SELECT CABLE
TRANSMISSION HOUSING.
MOUNTING BOLTS
FRONT ENGINE MOUNTING
(Engine side)
BOLT
(Transmission side)
/ B O L T
H O U S I N G
COVER