Run-Out Inspection - Honda Acura NSX 1991 Service Manual

12. Install and tighten the two caliper mounting bolts.
110 mm FLANGE BOLT)
13. Insert the cable through the arm and connect the
cable to the lever with the clevis pin and lock pin.
Install the cable clip securely.
PARKING BRAKE CABLE
14. Install the caliper shieled.
NOTE: Clean the mating surfaces of the wheel
hub before installing the wheel.
Rear Brake Disc
1 . Raise each side of the car and, support on safety
stands (page l-6 through 81.~ Remove the rear
wheels.
Remove the brake pads (page 19-l 7).
2.
Inspect the disc surface for grooves, cracks, and
3.
rust. Clean the disc thoroughly and remove all rust.
Use suitable nuts !I 2 x 1.5 mm) and plain washers
4.
to hold the disc securely against the hub, then
mount a dial indicator as shown.
Brake Disc Runout:
Service Limit: 0.10 mm (0.004 in)
Max. Refinishing Limit: 19 mm '(0.75 in)
If the disc is beyond the service limit, refinish the
5.
rotor.
NOTE: A new disc should be refinished if its
and
PLAIN WASHER
19-19