Honda Acura NSX 1991 Service Manual page 579

Steering Wheel
-Installation
CAUTION:
Before installing the steering wheel, align the front
l
wheels straight ahead.
Be sure to install the harness wires so that they are
l
not pinched or interfering with other car parts.
l Do not replace the original steering wheel with any
other design, since it will make it impossible to proper-
ly install the airbag. (only use genuine HONDA replace-
ment parts)
straight ahead and that steering wheel spoke angle
is correct. If minor spoke angle adjustment is neces-
sary, do so only by adjustment of the tie rods, not by
removing and repositioning the steering wheel.
ly attached to the steering wheel; otherwise, severe per-
sonal injury could result during later airbag deployment.
1. Before installing the steering wheel, center the ca-
ble reel.
Do this by first rotating the cable reel clockwise un-
til it stops.
Then rotate it counterclockwise (approximately two
turns) until:
The yellow gear tooth lines up with the mark on the
cover.
The arrow on the cable reel label points straight up.
YELLOW
ALIGNMENT MARK
ARROW MARK
GEAR TOOTH
2. Install the steering wheel.
NOTE: Be sure the steering wheel shaft engages the
cable reel.
3.
Insert the cruise control set/resume 4-P connector
and airbag connector to the steering wheel clips.
4. Connect the horn connector.
CRUISE CONTROL
SET/RESUME SWITCHES
CONNECTOR
HORN
CONNECTOR
50 N.m