Honda Acura NSX 1991 Service Manual page 854

Rear Window
4. Set the glass upright on the body, then center it in
the opening. Mark the location by marking lines
across the glass and body with a grease pencil at
the four points shown.
ALIGNMENT MARKS
5. Glue the rubber dams to the inside face of the glass
as shown to contain the adhesive during
installation.
NOTE: Be careful not to touch the glass where
adhesive will be applied.
12 mm (0.47 in.)
20-28
I
14
mm (0.55 in.)
6. With a sponge, apply a light coat of glass primer
around the edge of the glass as shown, then lightly
wipe it off with gauze or cheesecloth.
NOTE:
not get body and glass primer sponges mixed
hands. If you do, the adhesive may not bond to
the glass properly, causing a leak after the glass
is installed.
from the primed surface.
Upper Molding Section
7. With a sponge, apply a light coat of body primer to
the original adhesive remaining around the window
opening flange.
NOTE:
careful not to mix up glass and body primer
sponges.
hands.
Lower Molding
Section