Manitowoc Grove GMK 4100L-1 Maintenance Manual page 169

Having the brakes
repaired
G
Running in the
brake pads
S
Maintenance manual
GMK 4100L-1
•
Do not perform repair work on the vehicle brakes;
p. 7 - 77.
•
All repair work on the vehicle brakes may only be performed by
Manitowoc Crane Care
specialist workshop with specially trained repair crew.
•
Make sure that only original spare parts are used;
p. 7 - 76.
Risk of accidents due to uneven braking
If the brake pads and brake discs are replaced on only one side of the axle
then the wheels will brake unevenly.
Always have the brake pads and brake discs replaced on both sides of the
axle. Where axles lines have two brake calipers per brake disc, you must
always have the brake pads changed on both brake calipers.
New brake linings do not provide optimal braking and must therefore be
run in by periodic braking.
Risk of damage to the brakes when running them in
Constant or heavy braking at high speeds can overheat the brakes and
damage them.
The brakes must only be run in through periodic braking.
This must first be done at low speed and then later at medium speed.
•
Perform a test drive to make sure that the new brake pads are sufficiently
run in before putting the truck crane into normal operation.
or an authorised GROVE dealer or an authorised
3 302 364 en
Maintenance work on the carrier
7.11 Vehicle brake
à
Safety instructions ,
à
Spare parts and tools ,
7 - 81