Ats7 Set Number Of Seconds To Wait For Connection Completion; Ats8 Set Number Of Seconds To Wait For Comma Dialing Modifier; Ats10 Set Disconnect Delay After Indicating The Absence Of Data Carrier - Multi-Tech MultiModem EDGE Reference Manual

7.14 ATS7 Set Number of Seconds to Wait for Connection
Completion
Description:
Read Command Syntax:
Response(s):
Write Command Syntax:
Response(s):
Parameter Description:
<n>
Number of seconds to wait for connection completion 000...060 (Default is 060)
Notes:
•
Command ATS7 is applicable only to data calls.
•
Values greater than 60 (maximum 255) cause no error, but <n> will be restored to the maximum value of 60.
•
The correlation between ATS7 and ATS0 is important. If the called party has specified a high value for
ATS0=<n>, call setup may fail.
Example: Call setup may fail if ATS7=30 and ATS0=20.
7.15 ATS8 Set Number of Seconds to Wait for Comma
Dialing Modifier
Description:
Read Command Syntax:
Response:
Write Command Syntax:
Response:
Parameter Description:
<n>
0 DCE does not pause when "," encountered in dial string. Default.
1...255 Number of seconds to pause
7.16 ATS10 Set Disconnect Delay after Indicating the
Absence of Data Carrier
Description:
Read Command Syntax:
Response:
Write Command Syntax:
Response:
Parameter Description:
<n>
number of tenths of seconds of delay
001 - 254 Default is 2.
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371G)
ATS7 specifies the number of seconds the TA will wait for the completion of the call setup
when answering or originating a data call. Also referred to as "no answer timeout". To put
it plainly, this is the time to wait for the carrier signal. If no carrier signal is received within
the specified time, the TA hangs up.
ATS7?
<n>
OK
ATS7=<n>
OK
ERROR
No effect for GSM. This command specifies the amount of time, in seconds, that the DCE
shall pause, during signaling of call addressing information to the network (dialing), when
a "," (comma) dial modifier is encountered in a dial string.
ATS8?
<n>
OK
ATS8=<n>
OK
ERROR
This parameter setting determines the amount of time that the TA remains connected in
absence of a data carrier.
If the data carrier is detected before disconnect, the TA remains connected.
ATS10?
<n>
OK
ATS10=<n>
OK
ERROR
Chapter 7 – Call-Related Commands
88