At^smong Gprs Monitor; At^smong Cell Info Table - Multi-Tech MultiModem EDGE Reference Manual

8.12 AT^SMONG GPRS Monitor

Description:
Test Command Syntax:
Response:
Exec Command Syntax:
Response:
Write Command Syntax:
Response:
Parameter Descriptions:
<table>
1 Cell Info Table
<period>
Display period in seconds
If <period> is omitted the cell data will be presented only once on a single line (as if Execute command was
issued).
If <period> is given, the cell data will be listed repeatedly on 10 data lines. Every 10
header, simply to repeat the column titles.
1...100
For compatibility with earlier products and to support legacy applications, often any input character will stop
Note:
the periodic output of the write command. But since this applies only in certain cases (depending on the
settings of AT+IPR), it is recommended to always use "at" or "AT".

8.12.1 AT^SMONG Cell Info Table

Example output for AT^SMONG:
GPRS Monitor
BCCH G PBCCH
0637 1 -
Columns of the cell info table:
Column Description
BCCH ARFCN of BCCH carrier
G G GPRS / EDGE status:
0 GPRS / EGPRS not available in currently used cell
1 GPRS available in currently used cell
2 GPRS attached
3 EGPRS available in currently used cell
4 EGPRS attached
Note: During a voice call or CSD connection, GPRS services are not available; and, consequently,
G=0 is displayed.
PBCCH If PBCCH is present, indication of ARFCN, else "-" or if Frequency Hopping is used "H"
PAT Priority Access Threshold (GSM Rec. 04.08 / 10.5.2.37b)
0 Packet access is not allowed in the cell
1 Spare, shall be interpreted as "000" (packet access not allowed)
2 Spare, shall be interpreted as "000" (packet access not allowed)
3 Packet access is allowed for priority level 1
4 Packet access is allowed for priority level 1 to 2
MCC Mobile Country Code
MNC Mobile Network Code
NOM Network Operation Mode (1...3)
TA Timing Advance Value
RAC Routing Area Code (as hexadecimal value)
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371G)
The AT^SMONG command supplies GPRS specific cell information. There are two ways
to retrieve the information: once on request by using the execute command or
automatically every <period> seconds by using the write command. To stop the periodic
presentation type "AT" or "at".
AT^SMONG=?
^SMONG:(list of supported <table>s), (list of supported <period>s)
OK
ERROR
+CME ERROR
AT^SMONG
GPRS Monitor
Cell Info Table (see: Section 8.12.1, AT^SMONG Cell Info Table)
OK
ERROR
+CME ERROR
AT^SMONG=<table>[, <period>]
^SMONG: GPRS Monitor
Cell Info Table (see: Section 8.12.1, AT^SMONG Cell Info Table)
OK
ERROR
+CME ERROR
PAT MCC MNC
4 234 05
Chapter 8 – Network Service Commands
NOM TA RAC
2 00 0B
th
data line is followed by the
# Cell #
113