Atx Set Connect Result Code Format And Call Monitoring; At\ V Set Connect Result Code Format; Atz Set All Current Parameters To User Defined Profile - Multi-Tech MultiModem EDGE Reference Manual

2.6 ATX Set CONNECT Result Code Format and Call
Monitoring
Description:
Exec Command Syntax:
Response:
Parameter Description:
<value>
0
1
2
3
4

2.7 AT\ V Set CONNECT Result Code Format

Exec Command Syntax:
Response:
Parameter Description:
<value>
0
1
Notes:
•
For circuit-switched data calls only
• Output only if ATX parameter is set with value > 0.
2.8 ATZ Set all Current Parameters to User Defined
Profile
Description:
Exec Command Syntax:
Response:
Parameter Description:
<value>:
0
Notes:
• First the profile will be set to factory default (see AT&F). If there is a valid user profile (stored with AT&W), this
profile will be loaded afterwards.
•
Any additional commands on the same command line may be ignored. A delay of 300 ms is required before
next command is sent, otherwise "OK" response may be corrupted.
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371G)
ATX determines whether or not the TA detects the presence of dial tone and busy signal
and whether or not TA transmits particular result codes.
Store this parameter with the AT&W command.
Display this parameter with the AT&V command.
ATX<value>
OK
ERROR
CONNECT result code only returned, dial tone and busy detection are both disabled.
Default.
CONNECT <text> result code only returned, dial tone and busy detection are both
disabled.
CONNECT <text> result code returned, dial tone detection is enabled, busy detection is
disabled.
CONNECT <text> result code returned, dial tone detection is disabled, busy detection is
enabled.
CONNECT <text> result code returned, dial tone and busy detection are both enabled.
Default.
AT\ V<value>
OK
ERROR
CONNECT <text> result code returned without RLP trailer.
CONNECT <text> result code returned with RLP trailer. Default.
ATZ sets all current parameters to the user profile stored with AT&W. If a connection is in
progress, it will be terminated.
All defined GPRS contexts which are not activated or not online will be undefined if the
non-volatile storage of the CGDCONT settings is not activated by the AT^SCFG
parameter "GPRS/Persistent Contexts" (see AT+CGDCONT). The user defined profile is
stored to the non-volatile memory.
The user defined profile is stored to the non-volatile memory.
ATZ[value]
OK
Reset to user profile
Chapter 2 – Configuration Commands
21