At+Cgpaddr Show Pdp Address - Multi-Tech MultiModem EDGE Reference Manual

<Traffic handling priority>
This parameter specifies the relative importance for handling of all SDUs belonging to the UMTS bearer
compared to the SDUs of the other bearers.
0
1
2
3
<PDP_type>
Packet Data Protocol Type
"IP"
Notes:
• If parameters are not defined, the parameter default values depend on the HLR-stored subscribed default values.
•
Definitions of parameters can be found in 3GPP TS 23.107

11.9 AT+CGPADDR Show PDP Address

The test command returns a list of defined <cid>s.
Description:
The write command returns a list of PDP addresses for the specified context identifiers. If no
<cid> is specified, the addresses for all defined contexts are returned.
Test Command Syntax:
Response:
Write Command Syntax:
Response:
Parameter Descriptions:
<cid>
A numeric parameter which specifies a particular PDP context definition (see AT+CGDCONT command).
<PDP_address>
A string that identifies the MT in the address space applicable to the PDP. The address may be static or
dynamic.
Note:
If no <cid> is specified, the write command will return a list of all defined contexts.
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371G)
subscribed. Default
AT+CGPADDR=?
[+CGPADDR: (list of defined <cid>s)]
OK
AT+CGPADDR=[<cid>[,<cid>]]
[+CGPADDR: <cid>, <PDP_address>]
[+CGPADDR: <cid>, <PDP_address>]
OK
ERROR
+CME ERROR
Chapter 11 – GPRS Commands
182