At^sops Extended Operator Selection - Multi-Tech MultiModem EDGE Reference Manual

8.3 AT^SOPS Extended Operator Selection

AT^SOPS queries the present status of the Multi-Tech wireless modem's network registration.
Description:
Since basic operator selection services are available with AT+COPS this command uses the
methods of the Enhanced Operator Name String (EONS) specification while handling operator
name strings. Additional EONS related information is available with AT^SIND.
AT^SOPS test command lists sets of five parameters, each representing an operator present in
the network.
A set consists of:
1.
2.
3.
4.
5.
Any of the parameters may be unavailable and will then be an empty field (,,).
The list of operators comes in the following order: Home network, networks referenced in SIM
and other networks.
After the operator list the Multi-Tech wireless modem returns lists of supported <mode>s and
<format>s. These lists are delimited from the operator list by two commas.
If the test command is used while an ongoing GPRS transfer, traffic will be interrupted for up to
one minute.
Test Command Syntax:
Response:
Parameter Descriptions:
<opStatus>
Status
0 unknown
1 operator available
2 current operator
3 operator forbidden
<eonsType>
Specification of the source of the operator name <eonsOperator>. Details of EONS-supplied operator name
types are available at AT^SIND.
<eonsOperator>
Operator name; format depends on the source of the operator name, specified by <eonsType>.
<servProvider>
Service Provider Name according to setting of Service No. 17 in the SIM Service Table (EF
<opName>
Operator name in numerical presentation contains the GSM Location Area Identification (LAI) number, which
consists of the 3-digit Mobile Country Code (MCC) plus the 2- or 3-digit Mobile Network Code (MNC). Parameter
is stored non-volatile to the SIM.
<mode>
Parameter is not applicable.
<format>
Parameter is not applicable.
The AT^SOPS Test command is only accepted by the module after a valid pin has been entered.
Note:
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371G)
an integer indicating the availability of the operator,
specification of the source of the operator name <eonsOperator>,
operator name according to EONS Table,
Service Provider Name from the SIM Service Table and
numeric format representation of the operator.
AT^SOPS=?
^SOPS:[list of present operator( <opStatus>, <eonsType>, <eonsOperator>,
<servProvider>, <opName>)s ], , (list of supported <mode>)s, (list of supported
<format>)s
OK
ERROR
+CME ERROR: <err>
Chapter 8 – Network Service Commands
).
SST
101