Audi Q7 2007 !
6
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
–
Remove bolts -1 ... 4- on left and right and detach engine
supports.
Note
Illustration shows engine support (left-side).
–
Using support bracket for V6 TDI engine -VAS 6095/1-4-,
secure engine to engine and gearbox support -VAS 6095-
as shown in the illustration.
1.4
Installing engine
Note
Renew self-locking nuts and bolts when performing assem-
♦
bly work.
Renew bolts which are tightened to a specified angle as
♦
well as oil seals and gaskets.
Hose connections and hoses for charge air system must be
♦
free of oil and grease before assembly.
Secure all hose connections with the correct type of hose
♦
clips (same as original equipment) ⇒ Parts catalogue.
Fit all cable ties in the original positions when installing.
♦
–
Install engine supports (left and right).
–
Check whether dowel sleeves for centring the engine/gear-
box assembly are fitted in the cylinder block; install dowel
sleeves if necessary.
Bearing bush for torque converter
–
On vehicles with automatic gearbox, check that bearing
bush -arrow- is inserted in rear of crankshaft. Drive in bear-
ing bush if necessary.
32
Repair Group 10 – Removing and installing engine
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ:1398556747 电话:18218750259