Audi Q7 2007 Workshop Manual page 39

更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259
Checking installation depth of torque converter
If the torque converter has been correctly installed, the dis-
tance -a- between the bottom contact surfaces at the thread-
ed holes in the torque converter and the contact surface on
the torque converter bell housing (with automatic gearbox
09D) is approx. 22 mm.
If the torque converter has not been completely inserted, this
distance will be approx. 10 mm.
–
Before bringing engine and gearbox together, turn torque
converter and drive plate on engine so that the holes or
tapped holes are in line with the opening for the removed
starter -arrows-.
–
To secure torque converter on drive plate, use only new
ribbed bolts of the correct type (same as original equip-
ment) as specified in ⇒ Parts catalogue.
–
Bolt gearbox to engine.
Note
Tightening torques apply only to lightly greased, oiled,
♦
phosphated or black-finished nuts and bolts.
Additional lubricant such as engine oil or gearbox oil may
♦
be used, but do not use lubricant containing graphite.
Do not use degreased parts.
♦
Tolerance for tightening torques
♦
Securing engine to gearbox
Item
1, 2
3 ... 5, 7
6
8 ... 10
A
Installation is carried out in the reverse order; note the follow-
ing:
–
Install power steering pressure line ⇒ Rep. Gr. 48.
–
Install starter ⇒ Rep. Gr. 27.
–
Install alternator ⇒ Rep. Gr. 27.
–
Install poly V-belt ⇒ page
–
Install ATF pipes ⇒ Rep. Gr. 37.
–
Secure front propshaft to transfer box ⇒ Rep. Gr. 39.
–
Install coolant pipes (rear left)
–
Install starter catalytic converter
–
Install particulate filter
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
±
15%.
Bolt
M10x70
M12x80
M12x70
M10x70
Dowel sleeves for centralising
39.
⇒ page
176.
⇒ page
204.
⇒ page 207.
Nm
45
80
80
45
1 Removing and installing engine
Audi Q7 2007 !
6
33