Audi Q7 2007 Workshop Manual page 128

Audi Q7 2007 !
6
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
–
Use puller -T10320- to pull off toothed belt drive sprocket.
–
Take off toothed belt drive sprocket together with toothed
belt.
–
Unscrew inner section of oil seal extractor -2085- 3 turns
out of outer section and lock with knurled screw.
–
Lubricate threaded head of oil seal extractor, place it in po-
sition and screw it into oil seal as far as possible (applying
firm pressure).
–
Loosen knurled screw and turn inner part against crank-
shaft until the oil seal is pulled out.
–
Clamp flats of oil seal extractor in vice and use pliers to re-
move seal.
–
Clean running surface and sealing surface.
–
Press in new oil seal as far as stop using press sleeve
-T10053- and hexagon bolt M10 x 1.25 x 40 -arrow-,
(e.g. from fitting sleeves -3241-
Installation is carried out in the reverse order; note the follow-
ing:
–
Install toothed belt for high-pressure pump
122
Repair Group 15 – Cylinder head, valve gear
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259
⇒ page
48.