Removing And Installing Tensioner For Poly V-Belt; Removing And Installing Vibration Damper - Audi Q7 2007 Workshop Manual

Audi Q7 2007 !
6
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
1.3 Removing and installing tensioner for poly
V-belt
Removing
–
Carefully pull engine cover panel off four retaining pins one
after the other -arrows-.
Note
Before removing, mark direction of rotation of poly V-belt with
chalk or felt-tipped pen. If the belt runs in the opposite direc-
tion when it is refitted, this can cause breakage.
–
Slacken poly V-belt by swivelling tensioner in direction of
-arrow-, using a lever with TORX 60 bit.
–
Remove poly V-belt from tensioning roller.
–
Unscrew bolts -arrows- and remove poly V-belt tensioner.
Installing
Installation is carried out in the reverse order; note the follow-
ing:
–
⇒ page
Install poly V-belt
Tightening torques
Component
Poly V-belt tensioner to engine
1.4

Removing and installing vibration damper

Removing
–
Carefully pull engine cover panel off four retaining pins one
after the other -arrows-.
40
Repair Group 13 – Crankshaft group
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259
39.
M8
M10
Nm
25
40