更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ:1398556747 电话:18218750259
Removing
•
Engine/gearbox removed.
–
Mark installation position of drive plate on crankshaft.
–
Attach counterhold tool -10-201- in order to loosen bolts.
–
Unbolt drive plate.
–
Take out shim located behind.
Installing
Installation is carried out in the reverse order; note the follow-
ing:
–
Fit shim (1.5 mm) onto crankshaft.
–
Install drive plate with washer (3.4 mm).
–
Use new bolts for securing.
–
Reverse position of counterhold tool -10-201- in order to
tighten bolts.
Tightening torque
Component
Drive plate to crankshaft
•
1)
Renew bolts.
•
2)
90° = one quarter turn.
2.3
Renewing crankshaft oil seal (timing chain
end)
Special tools and workshop equipment required
Fitting tool -T10122-
♦
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
Nm
30 + 90°
1)2)
2 Servicing work on timing chain end
Audi Q7 2007 !
6
55