The Last Few Sheets Are Left Uncut - Horizon Fitness PC-P430 Manual

2 - 6 The Last Few Sheets Are Left Uncut

Are the cutting stick and the knife OK?
Cutting Stick
One side of a cutting
1 2
stick can provide two
working lines. One
8 3
7 4
cutting stick can provide
eight working lines on
6 5
the four sides
■ If there is a groove on the cutting stick as shown in
the drawing above, the last few sheets are left uncut,
or the cutting edge is rough. Change the cutting stick
face or replace it. If the groove is shallow and the last
one sheet is left uncut, place few sheets under the
cutting stick. Prepare the sheets whose width is the
same as the cutting stick.
■ If the knife edge is worn, the dull knife causes the
louder cutting noise and the last few sheets are left
uncut. Replace the knife. Service technicians should
bring back the used knife.
The wear of the knife can not be seen by the eyes. The repeated
operation with the dull knife may result in machine malfunction.
The knife needs to be replaced earlier.
2
Troubleshooting
Is the knife height OK?
Lower
The adjustable range is ± 45 degrees. If
you turn the screw more, the screw may
be broken.
404018
2_6_1B
404018
2_6_1A
■ If the last few sheets left uncut just after replacing the
knife, the knife height is not correct. See page 9
and lower the knife.
The Last Few Sheets Are Left Uncut
Is the knife tilted?
Right-hand Screw
Lock Nut
Loosen
Adjusting
Screw
Left-hand Screw
Lock Nut
Loosen
■ If the sheets are left uncut on either side, see page
9 and adjust knife angle.
Locking Screw
Eccentric Pin
404018
2_6_1C
PC-P430
23