Table of Contents
Advertisement
Operating Procedures
This section explains how to operate the machine.
Turn on the power switch.
Rear View
Power Switch
Turn on the key switch.
Insert the key and turn it to the right.
The "Ready" LED
lights.
If the knife is not at the starting position, the
"Cutting" LED
will light.
See page 10 .
Monitor LED's
Ready
Cutting
Safety Cover Open
Key
Set the back-gauge to the cutting
length.
The back-gauge can be moved forward or back
using the adjusting knob. Use the scale to set the
back-gauge.
Back-gauge Adjusting Knob
Place the sheets.
Open the safety cover, and place the sheets so
that the edge of stack touches the back-gauge.
The sheets will be cut along the lighted cut line.
While the safety cover is open, the
will blink.
Ready
Cutting
Safety Cover Open
Safety Cover
Cut Line
11"x17"
2
Back-gauge
LED
(5)
Advertisement
Table of Contents
