Entering Service Screen (61Ii) - Horizon Fitness APC-61 Manual

1-5 Entering Service Screen
"Normal Cutting" Screen
"Maintenance" Screen
"Information" Screen
"Numeric Keypad" Screen
6 1 2
6
1 2
ent
6 1 2 ent
Press the buttons.
Total Count Input
Up to five digits can be entered using the
"numeric keypad" screen at once. Input the
numbers the first three digits and the last
four digits separately .
When the button is pressed, the
numeric keypad screen appears.
Special Functions
( -
05 08
01
= Total Count Setting
02
= Cutting Program Clear
=
Resetting Home Position and
03
Push-out Length to Default
=
Total Count and Count after
04
Replacing Knife
1-9
"Service" Screen
Motor Home Position Display
Refer to 1-7 for details.
are not used.)
The total counts is memorized on the control P.C.B.
When replacing the control P.C.B.,
1. Write down the total counts before replacing the P.C.B.
2. Replace a new P.C.B.
04
3. After replacement, press the button and the [OK] button to clear the total counts of a new P.C.B.
4. Press the 01 button and input the total count number you wrote down.
Press the button and the [OK] button. Saved cutting programs will be
02
deleted completely. Deleted cutting programs cannot be restored.
Press the button and the [OK] button. Home positioning value will be
03
set to 620.0, and the push-out length will be set to 50.0.
CAUTION Press the button and the [OK] button. Memorized total counts and
04
count after replacing knife will be set to zero.