Adjustment Of Cutting Line Width - Horizon Fitness APC-61 Manual

3-8 Adjustment of Cutting Line Width

When double cutting line appears or after
replacing the lamp, adjust as follows.
1. Pull up the control box at the back of this
machine so that the interior of the machine
can be seen.
Pull up
The socket of the bulb can be
seen over the arrow.
2. When double cutting line appears, adjust the
position of the socket for- and backwards.
Wrap an insulation tape
Control Box
Clamp
Hit the socket of the bulb pointed by the
arrow lightly with screwdriver with insu-
lated flat tip to adjut the position.
The part harden with a white silicon can be
seen. Insert a screw driver in this part. Pull
the electric cable to return the socket.
From the back
3. To make the cutting line clear, so that the
Bulb
(Operation Side)
WARNING
Put on gloves before rotating the lamp.
Knife Holder
The bulb has high temperature.
Knife
Ray
- Rotate the bulb with the socket.
- When grease sticks on the knife or at the
Lamp Folder
Socket
Bulb
From the front
3-9
filament is horizontal.
Set as the filament is horizontal
back of knife holder, cutting line breaks or
becomes thinner. Put a paper between the
clamp and knife to remove the grease.