Ntp-G15 Install The Common Control Cards - Cisco ONS 15454 Hardware Installation Manual

Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Figure 64: Y-Cable Module
Step 5 Return to your originating procedure (NTP).

NTP-G15 Install the Common Control Cards

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Caution Always use the supplied ESD wristband when working with a powered ONS 15454. For detailed instructions
on how to wear the ESD wristband, refer to the
and Cisco ONS
This procedure describes how to install the common control cards.
Redundant TCC2/TCC2P/TCC3 cards on Cisco ONS 15454 shelf (required)
AIC-I card (optional)
MS-ISC-100T (optional; for multishelf node configurations)
NTP-G7 Install the Power and Ground , on page 68
NTP-G14 Install DWDM Equipment, on page 123
Required
Onsite
Provisioning or higher
Platforms.
NTP-G15 Install the Common Control Cards
Electrostatic Discharge and Grounding Guide for Cisco CPT
Cisco ONS 15454 Hardware Installation Guide
131