Installing the ONS 15454 M2 Shelf
Step 5
Return to your originating procedure (NTP).
DLP-G294 Install LAN Wires in ONS 15454 M2
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1
Using a 0.51 mm² or 0.64 mm² (#22 or #24 AWG) wire or a standard CAT-5 Ethernet cable, connect the wires
to the RJ-45 connector.
Step 2
Return to your originating procedure (NTP).
NTP-G313 Install and Configure the TNC, TNCE, TSC, or TSCE Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This task installs the LAN wires in ONS 15454 M2.
Standard CAT-5 Ethernet cable straight-through for data terminal equipment
(DTE) or crossover for data circuit-terminating equipment (DCE) or RJ-45
connector
Crimping tool for RJ-45 connector
0.51 mm² or 0.64 mm² (#22 or #24 AWG) wire, preferably standard CAT-5
NTP-G267 Install the Power Module in the ONS 15454 M2 Shelf, on page 230
As needed
Onsite
None
This procedure describes how to install and configure the TNC, TNCE, TSC, or
TSCE card.
Redundant TNC/TNCE/TSC/TSCE cards on Cisco ONS 15454 M6 shelf (required)
Stand-alone TNC/TNCE/TSC/TSCE card on Cisco ONS 15454 M2 shelf (required)
NTP-G271 Install the Power and Ground to the ONS 15454 M2 Shelf, on page
239
NTP-G14 Install DWDM Equipment, page 1-66
Required
Onsite
Provisioning or higher
Cisco ONS 15454 Hardware Installation Guide
DLP-G294 Install LAN Wires in ONS 15454 M2
261