Cisco ONS 15454 Hardware Installation Manual page 62

NTP-G306 Install the ONS 15454 Shelf
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
The shelf, the air ramp, and the E1-75/120 conversion panel ship with the ETSI mounting brackets installed
as needed for installation in an ETSI rack. If you want to install the node in a 19-inch (482.6-mm) rack, the
ETSI mounting brackets of the shelf and the air ramp need to be replaced with the 19-inch (482.6-mm)
mounting brackets that shipped in the ship kit.
Procedure
Step 1
(ANSI shelves only) Complete the
(ANSI Only), on page 33
Step 2
(ANSI shelves only) To install the air filter on the bottom of the shelf rather than below the fan-tray assembly,
complete the
Step 3
Complete the necessary rack mount task as applicable:
• DLP-G678 Mount the ONS 15454 Shelf in a Rack (One Person), on page 36
• DLP-G679 Mount the ONS 15454 Shelf in a Rack (Two People), on page 37
• DLP-G680 Mount Multiple ONS 15454 Shelf Assemblies in a Rack , on page 39
• DLP-G8 Install the Air Ramp, on page 42
Step 4 Continue with the
Cisco ONS 15454 Hardware Installation Guide
32
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Pinned hex key
ETSI only:
• Two M6 x 20 socket set screws
• Eight M6 x 20 pan-head Phillips mounting screws
ANSI only:
• Two #12-24 x 3/4 set screws (48-1003-XX)
• Eight #12-24 x 3/4 pan-head Phillips mounting screws (48-1004-XX,
48-1007-XX)
NTP-G305 Unpack and Inspect the ONS 15454, ONS 15454 M2, and ONS 15454
M6 Shelves, on page 20
Required
Onsite
None
DLP-G3 Reverse the Mounting Bracket to Fit a 19-inch (482.6-mm) Rack
if you need to convert from a 23-inch (584.2 mm) to a 19-inch (482.6 mm) rack.
DLP-G4 Install the External Brackets and Air Filter (ANSI Only), on page
NTP-G3 Open and Remove the Front Door , on page
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
34.
56.