Dlp-G4 Install The External Brackets And Air Filter (Ansi Only) - Cisco ONS 15454 Hardware Installation Manual

DLP-G4 Install the External Brackets and Air Filter (ANSI Only)

Figure 12: Reversing the Mounting Brackets (23-inch [584.2-mm] Position to 19-inch [482.6-mm] Position
Step 7 Return to your originating procedure (NTP).
DLP-G4 Install the External Brackets and Air Filter (ANSI Only)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
To install the air filter inside the air ramp unit (15454E-AIR-RAMP or 15454-AIR-RAMP), use the ETSI
version of the air filter (15454-FTF2 or 15454E-FTF4).
Cisco ONS 15454 Hardware Installation Guide
34
This task installs the external brackets and air filter on the bottom of the shelf
rather than below the fan-tray assembly. Installing the external brackets and air
filter on the bottom of the shelf enables access to the air filter without removing
the fan-tray assembly. This task applies to the ONS 15454 ANSI shelf only.
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
DLP-G3 Reverse the Mounting Bracket to Fit a 19-inch (482.6-mm) Rack (ANSI
Only), on page 33, if applicable
As needed
Onsite
None
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf