Cisco ONS 15454 Hardware Installation Manual page 353

Installing the ONS 15454 M6 Shelf
NTP-G258 Install the Standard Door of the ONS 15454 M6 Shelf
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1 Pull the hinge pins on the standard door in the opposite directions (see the following figure).
NTP-G258 Install the Standard Door of the ONS 15454 M6 Shelf
This procedure installs the standard door of the ONS 15454 M6 shelf.
#2 Phillips Dynamometric screwdriver
• NTP-G259 Open and Remove the Standard Door of the ONS 15454 M6
Shelf , on page 327
• NTP-G252 Install the ONS 15454 M6 Shelf , on page 294
• Connect the chassis to the office ground. For detailed instructions on how
to ground the chassis, see the
for Cisco CPT and Cisco ONS
• NTP-G253 Install the ECU or ECU-S Module, on page 349
• NTP-G524 Install the Power Modules in the ONS 15454 M6 Shelf , on page
355
• NTP-G255 Install the LCD Module in the ONS 15454 M6 Shelf, on page
366
• NTP-G256 Install Power and Ground to the ONS 15454 M6 Shelf , on page
370
• NTP-G257 Install the Fan-Tray Assembly in the ONS 15454 M6 Shelf, on
page 388
• NTP-G290 Install the Cable and Fiber Modules, on page 391
• NTP-G312 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections
in Cisco ONS 15454 M6, on page 397
As needed
Onsite
None
Cisco ONS 15454 Hardware Installation Guide
Electrostatic Discharge and Grounding Guide
Platforms.
323