Setting The System Time And Date With Ntp - Cisco 1120 Installation Manual

Reconfiguring CSACS 1120 System Parameters
To set the CSACS 1120 system time and date manually:
Log in to the CSACS 1120. For more information, see
Step 1
Console.
At the system prompt, enter
Step 2
Result: The console displays:
Current Date/Time Setting:
Time Zone: (GMT -xx:xx) XXX Time
Date and Time: mm/dd/yyyy hh/mm/ss
NTP Servers: ("Ntp Synchronization Disabled" - or -a list of NTP servers)
Change Date & Time Setting? [N]
At the
Step 3
press Enter.
Result: The console displays a list of indexed time zones and the following message:
[xx] (GMT -xx:xx) XXX Time.
Enter desired time zone index (0 for more choices) [x]:
At the
Step 4
zone index number from the time zone setting list, and press Enter.
Tip
Result: The console displays the new time zone.
Step 5 At the
Step 6 At the
At the
Step 7
Result: The system time is reset.

Setting the System Time and Date with NTP

You can set and maintain the system date and time by using one of two methods:
•
•
To set the CSACS 1120 system time and date manually, see
To set the CSACS 1120 system time and date with NTP:
Step 1 Log in to the CSACS 1120. For more information, see
Console.
Step 2 At the system prompt, enter
Result: The console displays:
Current Date Time Setting:
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
4-22
set time
Change Date & Time Setting? [N]:
Enter desired time zone index (0 for more choices) [x]:
You can also enter 0 (zero) and press Enter to see more time zone index numbers.
Synchronize with NTP Server?
Enter date [mm/dd/yyyy]:
Enter time [hh:mm:ss]:
Set the time and date manually.
Assign a NTP server with which the system synchronizes its date and time. (You can configure
backup NTP servers if you desire.)
set time
Chapter 4 Administering the Cisco 1120 Secure Access Control Server
Logging In to the CSACS 1120 from a Serial
, and press Enter.
prompt, to set the time zone, time, or date enter
prompt, enter , and press Enter.
N
prompt, enter the date, and press Enter.
prompt, enter the current time, and press Enter.
Setting the System Time and Date
Logging In to the CSACS 1120 from a Serial
, and press Enter.
, and
Y
prompt, enter the desired time
Manually.
OL-19455-01