Dlp-G26 Install The Tl1 Craft Interface Wires (Ansi Only) - Cisco ONS 15454 Hardware Installation Manual

Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
A frame ground pin is located beneath each pin field (FG2 for the LAN pin field). Wrap the ground shield of
the LAN interface cable to the frame ground pin.
LAN pin assignments.
Table 19: LAN Pin Assignments for the ONS 15454 ANSI Shelf
Pin Field
LAN 1 Connecting to DCE
LAN 1Connecting to DTE (a PC/workstation or router)
Note
Step 2 Return to your originating procedure (NTP).

DLP-G26 Install the TL1 Craft Interface Wires (ANSI Only)

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
3
(a hub or switch);
3
The ONS 15454 ANSI is a DCE.
The TCC2/TCC2P/TCC3 does not support Ethernet polarity detection. If your Ethernet connection
has incorrect polarity (this can only occur with cables that have the receive wire pairs flipped), a
LAN Connection Polarity Reversed (LAN-POL-REV) condition is raised. This condition usually
occurs during an upgrade or initial node deployment. To correct the situation, ensure that your
Ethernet cable has the correct mapping of the wire-wrap pins.
This task installs the TL1 craft interface on the ONS 15454 ANSI shelf using the
craft backplane pins. You can also use a LAN cable connected to the
TCC2/TCC2P/TCC3 EIA/TIA-232 port to access a TL1 craft interface.
Wire wrapper
#22 or #24 AWG (0.51 mm² or 0.64 mm²) alarm wires
NTP-G5 Remove the Backplane Covers (ANSI Only), on page 63
As needed
Onsite
None
DLP-G26 Install the TL1 Craft Interface Wires (ANSI Only)
Table 13: LAN Pin Assignments, on page 99
Backplane Pins RJ-45 Pins
B2 1
A2 2
B1 3
A1 6
B1 1
A1 2
B2 3
A2 6
Cisco ONS 15454 Hardware Installation Guide
shows the
Function/Color
TX+ white/green
TX– green
RX+ white/orange
RX– orange
RX+ white/green
RX– green
TX+ white/orange
TX– orange
111