How To View The User Log Counters; How To Install A Service Control Application; Cascaded Systems; How To Install A Cascaded System - Cisco SCE8000 GBE Installation And Configuration Manual

Chapter 6 Cabling the GBE Line Ports and Completing the Installation

How to View the User Log Counters

You should view the user log for errors that occurred during the installation process.
At the SCE> prompt, type show logger device User-File-Log counters and press Enter.
Step 1
SCE>show logger device user-file-log counters
Logger device User-File-Log counters:
Total info messages: 1
Total warning messages: 0
Total error messages: 0
Total fatal messages: 0
If there are "Total error messages" or "Total fatal messages", use the show logger device User-File-Log
command to display details about the errors.

How to Install a Service Control Application

The Service Control solution requires that the Service Control application be installed on the SCE
platform. This is a pqi file that is installed and configured using the Cisco Service Control Application
for Broadband (SCA BB) console.
For an explanation of how to install the pqi file, see
SCE Platform"
For information on initial configuration of the application, see
Cisco Service Control Product Installation
For complete instructions on how to install and configure the SCA BB application, see the
Control Application for Broadband User

Cascaded Systems

•
•

How to Install a Cascaded System

This section outlines the installation procedures for a redundant solution with two cascaded Cisco
SCE8000 GBE platforms. Refer to the
commands.
When working with two Cisco SCE8000 GBE platforms with split-flow and redundancy, it is extremely
important to follow this installation procedure.
Install both Cisco SCE8000 GBE platforms, power them up, and perform the initial system
Step 1
configuration. (See
the Management
OL-19897-02
in the Cisco Service Control Product Installation
How to Install a Cascaded System, page 6-13
CLI Commands for Cascaded Systems, page 6-15
Chapter 4, "Installing the Cisco SCE8000 GBE
Interfaces"and
"Installing the Application and Protocol Pack on the
Guide.
Guide.
Cisco SCE8000 CLI Command Reference
Starting the Cisco SCE8000 GBE Platform, page
Cisco SCE8000 GBE Installation and Configuration Guide
How to Install a Service Control Application
Guide.
"Initial SCA BB Configuration" in the
for details of the CLI
Chassis"and Chapter 5, "Connecting
7-1.)
Cisco Service
6-13