Cisco ONS 15454 Hardware Installation Manual page 346

DLP-G566 Mount the ONS 15454 M6 Shelf on a Rack (One Person)
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
The ONS 15454 M6 requires a minimum of six RU of vertical rack space. To ensure that the mounting is
secure, use two to three M6 mounting screws on each side of the shelf. A shelf should be mounted at the
bottom of the rack if it is the only unit in the rack.
Procedure
Step 1 Verify that the proper fuse and alarm panel has been installed in the top mounting space. If a fuse and alarm
panel is not present, you must install one according to manufacturer instructions:
• For a DC power supply, the fuse rating must not exceed 40A.
• For an AC power supply, the fuse rating must not exceed 10A, 15A, or 20A. For North America, the
branch circuit protection must be rated 20A. The overcurrent/short circuit protection must be in accordance
with local and national electrical codes.
Step 2
Ensure that the shelf is mounted on the appropriate rack equipment:
• 23-inches (584.2 mm) or 19-inches (482.6 mm) for ANSI racks. The recommended 19-inch ANSI rack
for the ONS 15454 M6 shelf is shown in
ONS 15454 M6 and M2 Shelves, on page
• 600 x 600-mm (23.6 x 23.6-inch) or 600 x 300-mm (23.6 x 11.8-inch) for ETSI racks.
Diagram 1 of
shelf mounted on an ANSI rack in the middle position using 19-inch mounting brackets.
Diagram 2 of
shelf mounted on an ETSI rack in the front position.
Cisco ONS 15454 Hardware Installation Guide
316
• # 2 Phillips Dynamometric screwdriver
• ANSI—Six #12-24 x ¾ pan-head Phillips mounting screws
• ETSI—Six M6 mounting screws
NTP-G305 Unpack and Inspect the ONS 15454, ONS 15454 M2, and ONS 15454
M6 Shelves, on page 20
As needed
Onsite
None
Figure 214: Mounting an ONS 15454 M6 on a Rack, on page 317
Figure 214: Mounting an ONS 15454 M6 on a Rack, on page 317
Figure 1: 19-inch ANSI Rack Post Recommended for Cisco
3.
Installing the ONS 15454 M6 Shelf
shows the ONS 15454 M6
shows the ONS 15454 M6