Install Pp-Mesh On An Ansi 19" Configuration - Cisco ONS 15454 Hardware Installation Manual

Install PP-Mesh on an ANSI 19" Configuration

Figure 80: ANSI and ETSI Brackets
Serial Number
1
2
3
Figure 81: Vertical Cable Guides (Left and Right)
Install PP-Mesh on an ANSI 19" Configuration
This procedure describes the steps to install the PP-Mesh on an ANSI 19" configuration:
Procedure
Step 1
Set the mounting brackets to the rack you are using.
Step 2 Install the right and left ANSI 19" bracket to the unit using the four washer and the screws provided with the
installation kit.
Cisco ONS 15454 Hardware Installation Guide
164
Specifications
ANSI Version- 19" Configuration: Long side mated to unit
ANSI Version- 23" Configuration: Short side mated unit
ETSI Version
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf