Dlp-G594 Open The Standard Door Of The Ons 15454 M2 Shelf - Cisco ONS 15454 Hardware Installation Manual
Hide thumbs
Also See for ONS 15454:
- Troubleshooting manual (107 pages) ,
- Manual (88 pages) ,
- Procedure manual (62 pages)
Table of Contents
Advertisement
Installing the ONS 15454 M2 Shelf
Stop. You have completed this procedure.
DLP-G594 Open the Standard Door of the ONS 15454 M2 Shelf
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution
The ONS 15454 M2 shelf has an ESD plug input and is shipped with an ESD wrist strap. The ESD plug input
is located on the outside of the shelf on the right side. It is labeled "ESD" on the top and bottom. Always wear
an ESD wrist strap and connect the strap to the ESD plug when working on the ONS 15454 M2. For detailed
instructions on how to wear the ESD wristband, refer to the
grounding/guide/esd_grounding.html
Procedure
Step 1
Loosen the standard door screws.
Step 2
Push the latches in the opposite direction as shown in the following figure.
Figure 139: Opening the Standard Door
DLP-G594 Open the Standard Door of the ONS 15454 M2 Shelf
This task opens the standard door of the ONS 15454 M2 system.
#2 Phillips Dynamometric screwdriver
•
NTP-G266 Install the ONS 15454 M2 Shelf, on page
•
NTP-G269 Install the Standard Door of the ONS 15454 M2 Shelf, on page
216.
• Connect the chassis to the office ground. For detailed instructions on how
to ground the chassis, refer here.
Required
Onsite
None
.
Cisco ONS 15454 Hardware Installation Guide
194.
http://www.cisco.com/en/us/docs/optical/esd_
219
Advertisement
Table of Contents
