Tl1 Craft Interface Installation - Cisco ONS 15454 Hardware Installation Manual

Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Before you can connect an ONS 15454 ANSI to other ONS 15454 ANSI shelves or to a LAN, you must
change the default IP address that is shipped with each ONS 15454 ANSI (192.1.0.2).
Table 13: LAN Pin Assignments
Pin Field
LAN 1 Connecting to data circuit-terminating equipment (DCE
switch)
LAN 1Connecting to data terminal equipment (DTE) (a PC/workstation or
router)
1

TL1 Craft Interface Installation

You can use the craft pins on the ONS 15454 ANSI backplane or the EIA/TIA-232 port on the
TCC2/TCC2P/TCC3 faceplate to create a VT100 emulation window to serve as a TL1 craft interface to the
ONS 15454 ANSI. Use a straight-through cable to connect to the EIA/TIA-232 port. The following table
shows the pin assignments for the CRAFT pin field.
Note
You cannot use the craft backplane pins and the EIA/TIA-232 port on the TCC2/TCC2P/TCC3 card
simultaneously.
Note To use the serial port craft interface wire-wrap pins on the backplane, the DTR signal line on the backplane
port wire-wrap pin must be connected and active.
Table 14: Craft Interface Pin Assignments
Pin Field
Craft
The Cisco ONS 15454 ANSI is DCE.
Contact Function
A1 Receive
A2 Transmit
A3 Ground
A4 DTR
TL1 Craft Interface Installation
Backplane Pins
1
, a hub or B2
A2
B1
A1
B1
A1
B2
A2
Cisco ONS 15454 Hardware Installation Guide
RJ-45 Pins
1
2
3
6
1
2
3
6
99