Dlp-G371 Install The Ethernet Adapter Panel; Dlp-G352 Install The Y-Cable Module Tray - Cisco ONS 15454 Hardware Installation Manual

DLP-G371 Install the Ethernet Adapter Panel

DLP-G371 Install the Ethernet Adapter Panel
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1
The EAP requires 1 RU in a standard 19-inch (482.6-mm), 23-inch (584.2-mm)/600 mm x 600mm, or 600
mm x 300 mm rack. Locate the RMU space specified in your site plan.
Step 2 Verify that the mounting brackets attached to the unit are correct for your rack size. Complete the
Reverse the Mounting Bracket to Fit a 19-inch (482.6-mm) Rack (ANSI Only), on page 33
Step 3 Align the chassis with the rack mounting screw holes, insert the four screws, and tighten.
Caution
Step 4
Repeat Steps 1 to 3 for the second EAP.
Step 5 Return to your originating procedure (NTP).

DLP-G352 Install the Y-Cable Module Tray

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 Hardware Installation Guide
126
This task installs an Ethernet adapter panel (EAP) in an ANSI or ETSI equipment
rack. The EAP is used in multishelf node configurations to connect the
MS-ISC-100T and the TCC2/TCC2P/TCC3 cards in the subtending nodes. Two
EAPs are required in a multishelf configuration, one for each MS-ISC-100T card.
#2 Phillips Dynamometric screwdriver
None
As needed
Onsite
None
Any paint between the EAP mounting ears and the frame of the metal rack must be removed. The
area must then be cleaned and coated with an antioxidant.
This task installs the Y-cable tray. The Y-cable tray can store up to eight Y-cable
protection units.
#2 Phillips Dynamometric screwdriver
Y-cable module tray(s) (15454-YCBL-LC)
Cisco TransportPlanner Internal Connections Report
None
As needed
Onsite
None
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
as required.
DLP-G3