Ethernet Adapter Panel - Cisco ONS 15454 Hardware Installation Manual

Ethernet Adapter Panel

Step 7
Enter the following commands to configure authentication:
Example:
Switch(config)#
Switch(config)#
Switch(config-line)#
Switch(config-line)#
Switch(config-line)#
Switch(config-line)#
Switch(config-line)#
Switch(config-line)#
Stop. You have completed this procedure.
Ethernet Adapter Panel
An ethernet adapter panel (EAP) is required in an ANSI or ETSI equipment rack for multishelf configurations.
Two EAPs are required in a multishelf configuration, one for each MS-ISC-100T card.
the EAP to the Node Controller and Subtending Shelf, on page 155
and the connection between each EAP and a node controller shelf and a subtending shelf.
An EAP cable is used to connect the MS-ISC-100T card ports to the EAP
155). The nine connector ends plug into Ports 0 through 8 of the MS-ISC-100T card, and the multiport connector
plugs into the EAP. Ports 0 and 1 on the MS-ISC-100T card are the DCN ports; Ports 2 through 7 are the SSC
ports. A cross-over (CAT-5) LAN cable is used to connect the DCN port on the EAP to the front panel of the
TCC2/TCC2P/TCC3 cards in the subtending shelves.
Cisco ONS 15454 Hardware Installation Guide
154
line con 0
line vty 0 4
password yyyyyy
login
line vty 5 15
password yyyyyy
login
end
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Figure 68: Connecting
shows an example of two installed EAPs
(Figure 69: EAP Cable, on page