Cisco ONS 15454 Hardware Installation Manual page 445

Installing the ONS 15454 M6 Shelf
Figure 278: Mixed Multishelf Configuration without a Catalyst Switch Using ONS 15454 M6 as the Node Controller
Step 4
Return to your originating procedure (NTP).
DLP-G683 Connect the ONS 15454 as the Node Controller in a Mixed Multishelf
Configuration
Purpose
Tools/Equipment
Prerequisite Procedures
DLP-G683 Connect the ONS 15454 as the Node Controller in a Mixed Multishelf Configuration
Use this procedure to connect the ONS 15454 as the node controller and a mix
of ONS 15454 and ONS 15454 M6 as subtending shelves using the Catalyst 3560.
• Two Cisco Catalyst 3560 switches must be installed in same rack as the node
controller shelf; refer to the Cisco Catalyst 3560 product documentation for
installation instructions.
• Cross-over (CAT-5) LAN cables
NTP-G15 Install the Common Control Cards, on page
NTP-G313 Install and Configure the TNC, TNCE, TSC, or TSCE Card, on page
261
Cisco ONS 15454 Hardware Installation Guide
131.
415