Ntp-G10 Attach Wires To Alarm, Timing, Lan, And Craft Pin Connections - Cisco ONS 15454 Hardware Installation Manual
Hide thumbs
Also See for ONS 15454:
- Troubleshooting manual (107 pages) ,
- Manual (88 pages) ,
- Procedure manual (62 pages)
Table of Contents
Advertisement
NTP-G10 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections
NTP-G10 Attach Wires to Alarm, Timing, LAN, and Craft Pin
Connections
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution
Always use the supplied ESD wristband when working with a powered ONS 15454 ETSI. For detailed
instructions on how to wear the ESD wristband, refer to the
Cisco CPT and Cisco ONS
Procedure
Step 1
For an ONS 15454 ETSI shelf, complete the following tasks as necessary:
• Complete the
• Complete the
• Complete the
Step 2
For an ONS 15454 ANSI shelf, complete the following tasks as necessary:
• Complete the
Cisco ONS 15454 Hardware Installation Guide
100
This procedure installs alarm, timing, LAN, and craft wires on the ONS 15454
shelf. These wires are attached to the mechanical interface card (MIC) FMECs
on the ETSI shelf and are attached to the backplane on the ANSI shelf.
Connectors according to function
Twisted #22 or #24 AWG (0.51 mm² or 0.64 mm²) shielded wires for LAN or
craft
75-ohm coaxial cable with 1.0/2.3 miniature coax connector
0.51 mm² or 0.64 mm² (#22 or #24 AWG) alarm wires
NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only), on page 66
NTP-G5 Remove the Backplane Covers (ANSI Only), on page 63
As needed
Onsite
None
Platforms.
DLP-G20 Install Alarm Wires on the MIC-A/P (ETSI Only), on page
provision external alarms and/or controls with the AIC-I card.
DLP-G21 Install Timing Wires on the MIC-C/T/P (ETSI Only), on page 104
provisioning external timing.
DLP-G22 Install LAN Wires on the MIC-C/T/P (ETSI Only), on page 105
external LAN connection. You must either install LAN wires on the MIC-C/T/P or connect a CAT-5
Ethernet cable to the LAN port on the TCC2/TCC2P/TCC3 card to create an external LAN connection.
DLP-G23 Install Alarm Wires on the Backplane (ANSI Only), on page 106
an AIC-I card and are not using an AEP.
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Electrostatic Discharge and Grounding Guide for
101if you want to
if you are
to create an
if you are using
Advertisement
Table of Contents
