EMC Celerra Command Reference Manual page 460

The server Commands
Ethernet
Gigabit Ethernet Fiber
Gigabit Ethernet
Copper
460
Celerra Network Server Command Reference Manual
speed={10 | 100 | 1000 |auto}
Sets the speed for the port. auto (default) turns on
autonegotiation; setting a fixed speed disables autonegotiation.
duplex={full | half | auto}
Sets the duplex to full, half, or auto. auto (default) turns
autonegotiation on; setting a fixed duplex disables
autonegotiation.
CAUTION
!
The speed and duplex settings on both sides of the physical
connection must be the same. Mismatched speed and duplex
settings can cause errors and impact network performance. For
example, if the duplex is set to half on one end and full on the
other, there might be network errors and performance issues.
For Gigabit Ethernet Fiber connections, the speed is automatically
set to 1000, and since it must remain at that setting, no speed
setting is required.
linkneg={enable | disable}
Disables autonegotiation on the network adapter card if it is not
supported by the network Gigabit switch. The default is enable.
rxflowctl={enable | disable}
Enables the ability to accept and process pause frames.The
default is disable.
txflowctl={enable | disable}
Enables pause frames to be transmited. The default is disable.
speed={10 | 100 |1000 |auto}
Sets the speed for the port. auto (default) turns on
autonegotiation; setting a fixed speed disables autonegotiation.
duplex={full | half | auto }
Sets the duplex to full, half, or auto. auto (default) turns
autonegotiation on; setting a fixed duplex disables
autonegotiation.