EMC Celerra Command Reference Manual page 165

UPSMonitor 23
UPSMonitor 24
UPSMonitor 25
UPSMonitor 26
battery signal cable
UPSMonitor 27
UPSMonitor 28
UPSMonitor 29
UPSMonitor 30
UPSMonitor 31
UPSMonitor 32
UPSMonitor 33
UPSMonitor 34
UPSMonitor 35
UPSMonitor 36
UPSMonitor 37
UPSMonitor 38
UPSMonitor 39
UPSMonitor 41
UPSMonitor 42
UPSMonitor 43
UPSMonitor 44
UPSMonitor 45
UPSMonitor 46
UPSMonitor 47
UPSMonitor 48
UPSMonitor 49
UPSMonitor 50
UPSMonitor 51
UPSMonitor 52
UPSMonitor 53
UPSMonitor 54
UPSMonitor 55
UPSMonitor 56
UPSMonitor 57
UPSMonitor 58
UPSMonitor 59
UPSMonitor 60
UPSMonitor 61
UPSMonitor 62
UPSMonitor 63
UPSMonitor 64
UPSMonitor 65
Environmental Monitor
UPSMonitor 66
Monitor
UPSMonitor 67
UPSMonitor 68
UPSMonitor 69
UPSMonitor 70
UPSMonitor 71
UPSMonitor 72
The UPS has returned from bypass mode
The base module bypass power supply needs repair
The base module fan needs repair
Communication lost with external battery packs, check
Communication established with external battery packs
A battery run time calibration test has been initiated
Agent restarting as commanded by manager
A UPS is turned on
The UPS has enabled SmartTrim(TM) voltage reduction
Authentication on agent code image is done
The overload condition has been cleared.
The UPS has returned from SmartBoost(TM)
The UPS has returned from SmartTrim(TM) voltage reduction
The UPS has returned from a bad battery fault
The UPS has finished calibrating
The UPS discharge condition has been cleared
A graceful shutdown has been initiated
Outlet has been turned on
Outlet has turned off
Outlet has rebooted
The SNMP configuration has been changed
Outlet configuration has been changed
Three unsuccessful logins have been attempted via the console
An unsuccessful attempt to login via HTTP
Someone has changed the password on the device
The output voltage is not within acceptable range
The output voltage has returned to an acceptable level
The battery charger has failed
The battery charger failure condition has been cleared
The battery temperature threshold has been violated
The battery over temperature has been cleared
SmartBoost(TM) or SmartTrim(TM) relay fault
SmartBoost(TM) or SmartTrim(TM) relay fault has been cleared
A humidity threshold has been violated on probe 1
A humidity threshold violation has been cleared on probe 1
A temperature threshold has been violated on probe 1
A temperature threshold violation has been cleared on probe 1
A humidity threshold has been violated on probe 2
A humidity threshold violation has been cleared on probe 2
A temperature threshold has been violated on probe 2
A temperature threshold violation has been cleared on probe 2
Communication established between the agent and the
Communication lost between the agent and the Environmental
The number of batteries has increased
The number of batteries has decreased
The number of power modules has increased
The number of power modules has decreased
An intelligence module has been inserted
An intelligence module has been removed
The nas Commands
165
nas_event