EMC Celerra Command Reference Manual page 382

The server Commands
Write Command PDUs
Response PDUs
Data-In PDUs
Data-Out PDUs
R2Ts
Tx Data Octets
Rx Data Octets
Digest Errors
Connection Timeout
Errors
EXAMPLE #20
$ server_iscsi server_2 -target -unbind t1 np=172.24.102.243:3260
server_2 : done
EXAMPLE #21
Value
Status
TCP Port
Header Digests
Data Digests
Session Failures
Last Session Failed
Login Accepts
Login Failed
382
Celerra Network Server Command Reference Manual
number of write command PDUs received by target.
number of iSCSI response PDUs sent by target.
number of data-in PDUs.
number of data-out PDUs.
number of request to transfers issued during the session.
amount of transmitted data (in bytes).
amount of received data (in bytes).
number or errors in data and/or header digests.
number of errors caused by the connection between target and initiator timing out.
To unbind the network portal 172.24.102.243:3260 on a target, t1,
type:
To display the status of the iSCSI service, iSCSI session statistics and
statistics about login/logout attempts, type:
$ server_iscsi server_2 -service -status
server_2 :
**** ISCSI Service ****
Status: Running
Iscsi is configured to listen on ports:
TCP Port: 3260
Header Digests are preferred
Data Digests are not preferred
[Session Stats]
Session Failures: 0
Last Session Failed: N/A
[Login/Logout Stats]
Login Accepted: 0
Login Failed: 0
Redirect: 0
Authorize: 0
Authenticate: 0
Negotiate: 0
Other: 0
Logout Normal: 0
Logout Other: 0
Last Login Failed: N/A
Where:
Definition
status of the iSCSI service on the Data Mover.
listening port used by the iSCSI service.
whether header digests are enabled or disabled.
whether data digests are enabled or disabled.
number of session failures.
ID of the last failed session.
number of accepted login requests.
number of rejected login requests.