Server_Setup - EMC Celerra Command Reference Manual

server_setup

SYNOPSIS
server_setup {<movername> | ALL}
-type {nas | standby}
| -Load <image_name>
| -Protocol {cifs | mpfs | viruschk | rip | cdms}
{-option [start[=<n>]
| stop[,comment=<message>]
| delete]}
DESCRIPTION
OPTIONS
Manages the type and protocol component for the specified Data
Mover(s).
server_setup sets up the type and protocol component for the
specified Data Mover.
The ALL option executes the command for all of the Data Movers.
-type {nas | standby
Reboots the Data Mover as the type specified. When setting up a
standby relationship between a primary Data Mover and a standby,
make sure that the standby Data Mover has the same disk
configuration as the primary.
-Load <image_name>
Loads an image onto a Data Mover. The image may be an emergency
patch or debug image provided by EMC. Do not use this option
unless directed by EMC customer
-Protocol {cifs | mpfs | viruschk | rip | cdms}
Selects the protocol configuration to be managed. Multiple protocol
configurations can be enabled for a Data Mover.
Note: NFS and RIP processing are enabled by default. NFS cannot be
disabled.
-option
Specifies the following options for the specified protocol:
start
Starts the specified protocol configuration. To verify whether the
protocol configuration has started, use the respective server
command for the protocol.
}
service.
The server Commands
451
server_setup